SEGMENTED PAD WIDE BELT SANDER
1.). Fully automatic computer control interface, from there show the problem, adjust the working height
and display the status. Automatically save power when not running.
2).The first sanding shaft is a cross-section sanding shaft with a flexible cross-section keyboard with a liner.
3). The 2nd shaft is with 25~30Sh rubber coated roller.
4). Third shaft with flexible cross-section piano pad + standard pad for longitudinal sanding.
5). Electronically controlled and infrared sensor oscillates automatically to keep the sanding belt at
6) .Automatic stop device (when belt is moved or broken).
7). The frequency converter regulates the conveyor speed.
8). Emergency stop device.
9). Rollo pressed.
ten). Oscillating & dust blowing system.
11). The power goes up and down the workbench.
twelfth). Frequency converter for three sanding units.
13). Cleaning brush unit.
14). Vacuum equipment.
|Thickness working||: 3-100 mm|
|Working length||: ≥ 500 mm|
|Motor shaft 1||: 11 kw|
|Motor shaft 2||: 11 kw|
|Motor shaft 3||: 11 kw|
|Rush roller motor||: 0.37 kw|
|Conveyor motor||: 4 kw|
|Lift table motor||: 0.75 kw|
|Vacuum motor||: 7.5 kw|
|1. shaft working speed||: 3-15 m/s|
|2. shaft working speed||: 3-15 m/s|
|3. shaft working speed||: 3-15 m/s|
|Conveyor speed||: 3-18 m/s|
– This machine is suitable for sanding the primer surface.
– First, horizontal sanding is done for horizontal sanding of the board, then soft rubber roller and sanding pad are used for longitudinal sanding, diagonal sanding. The segmental main sanding table can perform segmental sanding on the workpiece to ensure good sanding effect.
– The machine is controlled by PLC, operated by touch screen, equipped with automatic warning device, the screen shows the error clearly at a glance, helping to quickly identify the faulty device for quick handling. .
– The dust collector must be turned on before the sanding machine runs, the external resistance of the dust collector pipe should be less than 106 Ω, the required air flow of the machine is: 15000m3/h, the actual pressure is 2300Pa and Wind speed is 15 ~ 20m/s.
See more: Wide belt sander