160 ton 3 Layers Veneer Hot Press is fit for the furniture factory or panel secondary processing plant, which can make lamination for furniture panel,building partition, wooden door or laminate all kinds of decorative material on man-made board. It also can be used for drying or leveling veneer.
Introduction of 160 Ton 3 Layers Veneer Hot Press
1. Adopt solid drilled conduction board, warming up faster, uniform thermal conductivity, and energy consumption lower.
2. Omron or Schneider main electric components, it is stable and durable.
3. Hawe valve from German for auto-open hydraulic valve, high holding pressure, reliable performance, less human factors.
4. Piston mode for cylinder. Grind, plate hard chromium on the surface and polish piston
after heat treatment. It is durable and high precision. Adopt special seal-rings for reliability and durability.
5. Mylar for in and out of the hose, external spoke flexible reinforced, using cycle is long and difficult to damage.
6. Configure pull E-stop switch, temperature secondary protection equipment.
Specifications 160 Ton 3 Layers Veneer Hot Press
|Total pressure||: 1600KN|
|Working layer||: 3|
|Unit pressure||: 4 kgf/cm2|
|Platen No & size||: 4 – 3200 x 1300 x 42 mm|
|Opening||: 120 mm|
|Cylinder No & diameter||: 10 & φ 85 mm|
|Heating way||: oil|
|Hot platen open way||: Automatically|
|Installation power||: 77.5 kw|
|Closeing speed||: 24 mm/s|
LAMINATING PRESS 160T HOT PRESS – SM214x8/16(3)HRC